| 1
Autoclave
tested by the ANCC at 6 atm. of pressure. Cover with "guillotine"
type closure, with 3 sealing rings. The lower ring is made
entirely of stainless steel: the cover is supported during
rotation by a monorail with carts on ball bearings. On the
cover, 2 inspection ports have been installed in order to
consent inspection the inside, which is illuminated by a
24-volt lamp. |
| 1
Rotating pump
with a high level of vacuum, in the event a high vacuum
of 759.5 Hg is required. |
| 2
Vats in iron sheet, with dimensions according
to the plant and autoclave capacity. The vats are used to
wash the impregnated parts. One of them is complete with
a heat exchanger to heat the water, as well as a device
to make it effervescent. |
| 1
Tank in iron, with
a capacity as required by the plant, for the deposit of
impregnating material. |
| 6
Baskets in
iron, with a cylindrical form and smooth chequered mesh,
for the impregnation of cast pieces or other material. |
| 1
Electric chain hoist, with an electric translator
and special low-voltage push-button panel, reinforced and
watertight, for the movement of the materials being processed. |
| 1
Pneumatic double-acting piston, equipped with
solenoid valve/timer and other material for operation. The
purpose of the piston is to assist and simplify washing
of the impregnated parts. |
| 1
Overhead crane in iron, complete with stand/frame,
etc., and an "ipe" beam to consent sliding of
the hoist. |
| 1
Electronic control panel for
the operation of the above-described equipment. |
| 1
Boiler
to heat the water. |
